Axminster CT344 Planer Blades 319mm T1 HSS Pack of 2 Knives Made in the UK by Xcalibur Tooling
Getting a dependable finish from a planer starts with knives that cut consistently across the entire width of the timber. These 319mm Xcalibur Tooling blades are produced specifically for the Axminster CT344 and supplied as a matched pair, making it straightforward to renew both cutter-block knives together.
Made in the UK from high-tungsten T1 High Speed Steel, the blades are fully heat-treated, stress-relieved, and precision ground to approximately a 40° cutting bevel. Their resharpenable design makes them well suited to workshops that regularly process hardwood and softwood and want to maintain accurate stock preparation over repeated use.
Key Features
-
319mm Machine-Specific Length: Each blade is manufactured to suit the Axminster CT344 planer/thicknesser, helping support accurate seating within the compatible cutter block.
-
T1 High Speed Steel Construction: High-tungsten T1 HSS provides dependable edge retention, toughness, and resistance to heat generated during continuous timber machining.
-
Matched Pack of Two: Both cutter knives are supplied together so they can be renewed as a pair, helping maintain similar blade height and cutting geometry.
-
Approximately 40° Bevel: The precision-ground cutting edge provides a useful balance between sharpness, durability, and surface quality.
-
Resharpenable Design: Once the cutting edges become dull, the knives can be sharpened again while sufficient blade material and correct geometry remain.
Applications
-
Surface rough-sawn boards before furniture making, cabinet construction, joinery, assembly, sanding, or finishing.
-
Bring hardwood and softwood stock closer to its required thickness before routing, shaping, sawing, or further machining.
-
Replace worn knives when the planer begins producing visible ridges, rough grain, increased tear-out, or inconsistent material removal.
-
For workshops operating an axminster thicknesser planer, keeping a spare matched pair available can help maintain productivity while another blade set is being sharpened.
-
Use the knives for routine stock preparation where controlled thickness and a cleaner, more consistent planed surface are required.
Why Choose Our Planer Blades?
-
The dedicated 319mm length provides a machine-specific replacement for the Axminster CT344 rather than relying on general-purpose planer knives.
-
T1 HSS combines durable cutting performance with the ability to be resharpened, helping extend the usable life of the blade set.
-
Replacing both knives together helps reduce differences in cutting height and wear that can occur when blades from different service cycles are mixed.
-
Controlled manufacturing tolerances support accurate cutter-block seating, helping promote balanced cutting and even material removal when correctly installed.
-
For workshops sourcing dependable wood tools uk, these UK-manufactured Xcalibur Tooling blades provide a practical replacement for maintaining accurate stock preparation.
FAQs
1. Are these blades made specifically for the Axminster CT344?
Yes. They are manufactured to the nominal length and cutting geometry required for the CT344 planer/thicknesser. Machine compatibility should still be confirmed before installation.
2. Can these 319mm planer knives be resharpened?
Yes. The T1 HSS construction allows the blades to be resharpened when their edges become dull. The original cutting angle and blade geometry should be maintained.
3. Can the blades be used on both hardwood and softwood?
Yes. T1 HSS is suitable for regular hardwood and softwood preparation. Cutting depth, feed rate, grain direction, and timber condition should still be considered during machining.
4. What can cause uneven results after fitting new knives?
Unequal knife projection, incorrect seating, loose fastening, or cutter-block setup can affect the finished surface. Both blades should be checked carefully before normal operation.
5. Why is it better to replace the blades as a pair?
Using a matched pair helps keep blade dimensions, cutting geometry, and wear levels more consistent. This can make accurate cutter-block adjustment easier and support a more uniform finish.





























